Recknagel Weaver/Picatinny Mounts for Zeiss Rail 45º (Tri-Nut)

Recknagel Weaver/Picatinny Mounts for Zeiss Rail with 45º
45º Angle is familiar with the modern Zeiss (ZM), Docter (Z Rail), Meopta (MR Rail), Minox (IS Rail), Leica (Leica Rail) and Schmidt & Bender (LMZ) Rail Scopes.
with Tri-Nut Fastening
Also available in Quick Release Lever Version

Height of Base - 7mm
Contents Supplied - 2x Tip-Off Mounts and Wrench Key
Code Ref: 57945-0700

These Tip-off mounts are designed to be used with the Zeiss Rail Rifle Scopes with the 45º angle, especially the Zeiss Diarange. Fit to both Weaver and Picatinny Rails. The mounts give a low overall height with the height of the bases being only 7mm. The 2 Tip off blocks have a weaver/picatinny profile and are mounted onto the rail and tightened using the supplied wrench.

Fitting Tips:
- Remove the two 45º Mounting Blocks from the Recknagel Mounts
- Drop the 45º Mounting Blocks into the Zeiss Rail slot, with the wider part of the block in first.
- Align the holes of the base component of the Recknagel Mount with the 45º Mounting Blocks, then fit the screw going through the Recknagel Mount into the 45º Mounting Block.
- Tighten the screws up fully for both of the 45º Mounting Blocks. Then afterwards slacken them off by a 1/8 turn.
- You are now able to slide the mount into position to suit the picatinny rail or weaver bases.
- We would advise to position the mount on the rail or bases one at a time, tighten up the 45º Mounting Block screws on one of the bases first.
- Once this is secured, repeat for the second base. Carefully align the second base in position and lift it off the rail/weaver base in order to tighten up the 45º Mounting Blocks.

The Recknagel Catalogue has a wide range of products available. If you would like any help with parts or fitting, feel free to call us on 01978 66 00 01. We can offer advise on the best possible solution, and a high quality scope mounting service.

The Recknagel Catalogue is available to browse online.