Krieghoff Barrel / Stock Stickers

£2.50
20% VAT incl.

Available Options

  • Model:BARREL-STICKER
Krieghoff Barrel / Stock Stickers
Available in Gold, Silver or White.

These high quality vinyl sticker with the "Krieghoff" text logo are designed to be transferred to your Krieghoff Barrels or Stock.

The stickers come as a set of two. So you can attach one either side of your barrels, or attach one to your barrel and one to your stock.

Size: 149mm x 17.5mm
Choose your colour from the drop-down menu above.

How to Apply your Stickers

Step 1 - Prepare It
Lay your sticker on a clean and flat surface with the backing tape (white side) face down and rub over the application tape (clear side) with your squeegee or credit card to ensure the application tape has a good bond to the vinyl letters.

Step 2 - Peel It
Check the positioning of where your sticker will go, so you're ready for the next stage.
Next, peel the application tape (clear side) away from the backing paper (white side). Your sticker letters will now be held by the application tape.
Carefully place the the application tape on to your barrels. Check the alignment as you place it down.

Step 3 - Rub It
While your sticker in laying on your barrels in position, start by rubbing over the application tape and letters gently, and then increase the pressure and firmly rub with your squeegee or credit card. Make sure you cover each letter thoroughly.

Step 4 - Remove It
Carefully peel away the application tape at an angle and corner to corner. The letters should all be transferred onto your barrel. If they are still attached to the application tape, lay the application tape back down and rub over the letter again with the squeegee or credit card. Now, try again until the whole sticker has been transferred.
Your new Krieghoff Barrel / Stock Sticker should now be in place and ready to show off.
If your letters are not coming away from the application tape as you're peeling the application tape off, lay the application tape back over the letter and use the squeegee to rub over the letter again.

Sticker Removal
If you decide to remove the stickers for any reason. Use some light heat such as a hair dryer to aid the removal. The adhesive is permanent but will not damage or mark your barrels. Do not use any abrasive materials or solvents to remove the stickers as this may cause damage to the finish of your barrels.

Postage
We send the Krieghoff Barrel & Stock Stickers with a piece of card to prevent the stickers from being damaged in transit.



You might also like...

2 x Recknagel One Piece Tip-off Mounts for Zeiss Rail [57045-0110]1 x Contessa Lightweight Alloy Picatinny Mount for Aimpoint3 x Schultz & Larsen Superdome IR Moderator (Over Barrel)3 x Krieghoff HIVIZ Pro Sights1 x VFG Barrel Cleaning Felts for 6mm (Box of 500)1 x VFG Intensive Barrel Cleaning Felts for 6mm (Box of 500)2 x Contessa Picatinny Rail - Anschutz 54/64 (0 MOA)2 x Krieghoff Premium ABS Case for Two Guns (K-80/K-20)1 x VFG Barrel Cleaning Felts for .44 (Box of 250)2 x Krieghoff Premium ABS Case for Two Barrels (K-80/K-20)2 x Contessa Chromed Picatinny Rail - Sako 75/85 X-Short, Adjustable (20 MOA)2 x Contessa Picatinny Rail - Sauer 200 Short (0 MOA)1 x Krieghoff Navy Gun Slip1 x Krieghoff Brass Front Sight Bead1 x Contessa CZ 452/455 Euro Rail Base for Quick Release Mount2 x Parker Hale Thread to 8-32 Thread Converter1 x Krieghoff K80 Speed Wrench for Factory Chokes1 x Krieghoff Spares Kit2 x Anschütz Biathlon Harness1 x Krieghoff Pro Choke Box1 x Krieghoff Trigger Screw2 x Schultz & Larsen Professional Bipod by Spartan1 x Krieghoff K-80 Sport Logo Cap Navy & Red2 x Krieghoff Woven Fabric Patch1 x Krieghoff "K" Denim Cap - Grey2 x Contessa Picatinny Rail - Sako 75/85 Short (0 MOA) Adjustable1 x VFG Barrel Cleaning Felts for 6mm (Box of 50)1 x VFG Adaptor for Parker Hale English Rods (up to 6.5mm)1 x Schultz & Larsen T-Handle Wrench (4mm Hex)1 x Contessa Tactical Picatinny Ring Mount, Black (with Rail) - 30mm1 x Contessa Tactical Picatinny Ring Mount, Brown (with Rail) - 30mm1 x Contessa Tactical Picatinny Ring Mount, Green (with Rail) - 30mm1 x Recknagel Picatinny Rail Tikka T3 / T3X, 0 MOA, Alu [..0081]1 x Contessa Picatinny Rail - Sauer 404 (0 MOA)1 x Chapman Precision Screwdriver Set 5575, 56 Piece - Master Set1 x Chapman Precision Screwdriver Set 5859, 44 Piece (SAE & Metric)2 x Chapman Precision Screwdriver Set 1000, 75 Piece - Mity Master1 x Ex-Demo Steel Factory Choke Tube, K-80 #2 (09)1 x Ex-Demo Steel Factory Choke Tube, K-80 #3 (08)1 x Ex-Demo Steel Factory Choke Tube, K-80 #3 (07)1 x Ex-Demo Steel Factory Choke Tube, K-80 #4 (06)1 x Contessa QD Mount for HIK-Micro Panther (Picatinny)1 x Recknagel Weaver Bases - Benelli ARGO [57080-3076]1 x Recknagel Weaver Bases - Browning X-Bolt [57080-301P]1 x Contessa Picatinny Rail - Browning A Bolt 1 Short (0 MOA)1 x Contessa QD Rear Extended Picatinny Rail Mount for Blaser1 x Contessa QD Forward Extended Picatinny Rail Mount for Blaser1 x Contessa QD Mount for Blaser R8/R93 for Schmidt & Bender Rail1 x Contessa QD Extra Extended Front & Rear Picatinny Rail - Blaser1 x Contessa QD Ultra Low Blaser Mount for Pulsar Night Vision1 x Recknagel Weaver Bases - Browning Mauser [..-3057]1 x Contessa QD Mount for ATN 4K Night Vision (Blaser)1 x Recknagel Weaver Bases - Haenel Jager 10 [..-302C]1 x Contessa Picatinny Rail - Blaser R8/R93 (0 MOA)1 x Recknagel Weaver Bases - Beretta 501 S [57080-3026]1 x Krieghoff Sight Bead Blanking Screw1 x ERATAC 30mm Ring with UNI-Interface [03680-5730]1 x ERATAC Offset Picatinny to UNI-Interface Adaptor [T0530-0000]1 x VFG Intensive Barrel Cleaning Felts for .22 (Box of 80)1 x Contessa Spare Rail Screws 6-48 x 8.5mm Long1 x ERATAC ACI Elevation Turret [T0941-0000]1 x Krieghoff "K" Logo Cap Navy & White1 x Recknagel Spare Screw 6-48 x 7.7mm [..587T]1 x Recknagel Spare Ring Cap Screw M3.5 x 7.4mm [..0880]1 x Contessa Lightweight Alloy Picatinny Mount for Docter Red Dot Sight1 x Recknagel Replacement Polyform Lever [00088-5700]1 x ERATAC ACI Bubble Level [T0940-0000]1 x Contessa Picatinny Rail - Ruger American (0 MOA)1 x Krieghoff Brass Mid Sight Bead1 x Contessa Spare Screw M10 for Anschutz/CZ Rails1 x Recknagel Spare Tri-Nut Wrench 00088-00861 x Recknagel Brass Front Sight Bead 2.5mm [11400-0250]1 x Recknagel Weaver/Picatinny Mounts for Zeiss 45º (QD Lever)1 x Recknagel Weaver/Picatinny Mount for Aimpoint Micro [57020-1200]1 x Contessa Quick Release Mount (Picatinny) for ATN X-Sight II1 x Contessa QD Mount for Blaser R8/R93 for Swarovski Rail1 x Krieghoff K-Diamond Beanie - Navy1 x Contessa Picatinny Rail - Tikka M590/M595 (0 MOA)1 x Contessa Quick Release Mount for Zeiss Rail1 x Recknagel Zeiss Rail 45º Components - 6mm BH1 x Recknagel Zeiss Rail 70º Components - 4mm BH1 x Contessa Ultra Low Quick Release Mount for Zeiss CP/Doctor1 x K-80 Barrel Weight Balance System1 x Recknagel Swarovski Rail Components for Optilock Base - 5mm BH1 x Contessa One Piece QD Picatinny Mount for Zeiss Rail1 x Contessa Quick Release Mount for Swarovski Rail1 x Recknagel SECURA Sling Swivel - 20mm Wide - 6mm [22009-1000]2 x Recknagel Steel Stock Trap Door1 x Schultz & Larsen Venom Moderator (Muzzle Mounted)1 x Recknagel Grip Cap Domed Blank [24000-0400]1 x Recknagel Grip Cap Skeleton Pointed [24060-0200]1 x Recknagel SOB01 Silencer (Standard Thread)1 x Jones Thru-the-Pad Adjuster2 x Recknagel SOB3D Silencer (Standard Thread)1 x Schultz & Larsen Thunderdome Moderator (Muzzle Mounted)1 x Recknagel SOB3D Silencer (ERA LOC)1 x Contessa Lightweight Alu Picatinny Rings - 34mm (8mm BH)1 x Recknagel SECURA Sling Swivel - 25.4mm Wide - 6mm [22009-3000]1 x AimZonic Compact Camo Sound Moderator2 x Krieghoff Factory Hanger Pin1 x Contessa Blued Steel Picatinny Rings - 35mm (8mm BH)1 x Schultz & Larsen Micro Moderator (Muzzle Mounted)1 x Recknagel Folding Front Sight Bead Ivory [11240-3565]1 x Recknagel Fibre Optic Front Sight Bead 8.5mm [11022-2585]1 x Recknagel Front Sight Bead Red [11444-0300]1 x Krieghoff Front Sight Bead (Standard)1 x ERATAC Backup Rear Sight for Picatinny [T0544-0355]1 x Recknagel Barrel Banded Front Ramp [12530-....]1 x Krieghoff Trigger & Selector Locking Wrench1 x Schmierfix Grease by Liqui Moly1 x MSA Sordin - Supreme Pro X Earmuffs (with Foam Seals)1 x Black Barrel Case (83cm Internal)1 x VFG 1 Piece Steel Cleaning Rod for 7mm and Upwards, with Adaptor1 x CR2032 Camelion Lithium Battery1 x Krieghoff 2011 Badge (Collectors Badge)1 x Bauer ED 8x50 Binoculars1 x Krieghoff Comb Wrench (T-Handle)1 x HJB 6-24x50 Rifle Scope (Mil-Dot)1 x Krieghoff K80 Speed Wrench for KTW Chokes1 x Briley T Wrench for K-80 Parcours Briley Chokes1 x VFG Magnetic Felt Clamps for Vices - 125mm1 x Contessa Schultz & Larsen Euro Rail Base for Quick Release Mount1 x Contessa Picatinny Rail - Anschutz 54 Only (10 MOA)1 x Contessa Picatinny Rail - Bergara B14 Long (20 MOA)1 x Contessa Picatinny Rail - Bergara B13 (0 MOA)1 x Contessa One Piece QD Extended Picatinny Rail Mount1 x Contessa 30mm Rings for Simple Black - 10.0mm (X-High)1 x Contessa Tactical One Piece QD Picatinny Ring Mount 30mm, 0 MOA1 x Contessa Bettinsoli Euro Rail Base for Quick Release Mount1 x Contessa Picatinny Rail - Browning A Bolt 1 Long (20 MOA)1 x Contessa CZ 527 Euro Rail for Quick Release Mount1 x Contessa Picatinny Rail - Sauer 90 (0 MOA)1 x Bauer HD 8x56 Binoculars1 x Clearance Americase Cordura Case Cover (32x11x3")1 x Krieghoff 2012 Badge (Collector's Badge)1 x Krieghoff Stock Removal Wrench1 x Krieghoff Stock - Parcours Non-Adjustable, LH, Cat 03 [8525]1 x Black Leather Shell/Cartridge Pouch1 x Contessa Picatinny Rail - Bergara B14 Short (20 MOA)
Manufacturers
Useful Information